MEGA 6/8/10/12 kW single-phase hybrid inverter — inverter fault
Beve 12 error code
The inverter's soft-start sequence failed.
Likely causes
- Heavy load or short on the output at the moment of start-up
- Internal pre-charge or soft-start circuit fault
- AC surge at the output during start-up
Checks to run, in order
- 1Switch off the output breaker, restart the unit and see whether code 12 clears
- 2Check the output for a short or an unusually heavy connected load
- 3Note whether the code appears only when a particular appliance is connected
Fixes
- Restart with no load connected, then bring loads on gradually
- Clear any output short before restarting
- If the code appears with no load, return the unit to the repair centre
When to escalate
If soft start fails with the output isolated, the distributor should inspect the soft-start and output stage.
Fix it with the right tools
Check the system around the fault before replacing parts: load, battery bank, PV string and commissioning settings. If you need a second opinion, send the code and your inverter model to our team.
Before you open the inverter
- Isolate both the AC and DC sides, then confirm the display is dead before touching terminals.
- Use insulated tools and one hand where possible. DC arcs do not self-extinguish like AC.
- If you see burnt terminals, swollen cells, leaking electrolyte or a burning smell, stop and escalate instead of resetting the fault.
Questions installers ask
What does Beve 12 mean?
The inverter's soft-start sequence failed.
How do I fix Beve 12?
Restart with no load connected, then bring loads on gradually Clear any output short before restarting If the code appears with no load, return the unit to the repair centre
When should I escalate Beve 12?
If soft start fails with the output isolated, the distributor should inspect the soft-start and output stage.
Can I reset Beve 12 myself?
Only after isolating the AC and DC sides and running the checks above. If Beve 12 returns immediately, stop resetting it and escalate; a repeating fault usually points to a real circuit, battery or hardware problem.
Which models show Beve 12?
Beve 12 is documented for MEGA 6/8/10/12 kW single-phase hybrid inverter — inverter fault. Confirm the code on your own unit's display or manual before ordering parts.
More Beve error codes
- Beve 01Cooling fan is locked and not turning while the inverter is switched on.
- Beve 02Inverter temperature has exceeded its protection point.
- Beve 03Battery voltage is above the inverter's high battery cut-off.
- Beve 05Output short circuit detected on the inverter AC output.
- Beve 06Inverter output voltage is above the acceptable window; the manual's troubleshooting table puts this above 260 Vac.
- Beve 07Overload: the inverter has been running above its rating (102% in the manual's note) until the overload time expired.
Guidance reviewed 17 October 2026 by the Mishka Energy installer team. Error codes vary by brand, model family and firmware; confirm against the manufacturer manual.
Back to troubleshooting