MEGA 6/8/10/12 kW single-phase hybrid inverter — inverter fault
Beve 17 error code
LLC resonant converter short-circuit fault.
Likely causes
- Power-stage component failure in the LLC converter
- Output short or over-current event damaging the power stage
- Internal gate driver fault
Checks to run, in order
- 1Isolate the output and restart once
- 2Check the output for a short before restarting
- 3Note whether the code appears immediately at start-up or only under load
Fixes
- Restart only after any output short is cleared
- Return the unit to the repair centre; an LLC fault is an internal power-stage failure
When to escalate
Code 17 should not be cleared by repeated restarts; the distributor must test the LLC power stage.
Fix it with the right tools
Check the system around the fault before replacing parts: load, battery bank, PV string and commissioning settings. If you need a second opinion, send the code and your inverter model to our team.
Before you open the inverter
- Isolate both the AC and DC sides, then confirm the display is dead before touching terminals.
- Use insulated tools and one hand where possible. DC arcs do not self-extinguish like AC.
- If you see burnt terminals, swollen cells, leaking electrolyte or a burning smell, stop and escalate instead of resetting the fault.
Questions installers ask
What does Beve 17 mean?
LLC resonant converter short-circuit fault.
How do I fix Beve 17?
Restart only after any output short is cleared Return the unit to the repair centre; an LLC fault is an internal power-stage failure
When should I escalate Beve 17?
Code 17 should not be cleared by repeated restarts; the distributor must test the LLC power stage.
Can I reset Beve 17 myself?
Only after isolating the AC and DC sides and running the checks above. If Beve 17 returns immediately, stop resetting it and escalate; a repeating fault usually points to a real circuit, battery or hardware problem.
Which models show Beve 17?
Beve 17 is documented for MEGA 6/8/10/12 kW single-phase hybrid inverter — inverter fault. Confirm the code on your own unit's display or manual before ordering parts.
More Beve error codes
- Beve 01Cooling fan is locked and not turning while the inverter is switched on.
- Beve 02Inverter temperature has exceeded its protection point.
- Beve 03Battery voltage is above the inverter's high battery cut-off.
- Beve 05Output short circuit detected on the inverter AC output.
- Beve 06Inverter output voltage is above the acceptable window; the manual's troubleshooting table puts this above 260 Vac.
- Beve 07Overload: the inverter has been running above its rating (102% in the manual's note) until the overload time expired.
Guidance reviewed 17 October 2026 by the Mishka Energy installer team. Error codes vary by brand, model family and firmware; confirm against the manufacturer manual.
Back to troubleshooting