MEGA 6/8/10/12 kW single-phase hybrid inverter — inverter fault
Beve 60 error code
Parallel failure: the code name refers to negative (reverse) power on a unit in the parallel system; the manual's description is simply 'Parallel failure'.
Likely causes
- Battery cables of unequal length or resistance between units
- A unit not enabled for parallel operation
- Parallel communication cable fault
- Mismatched battery capacity between units
Checks to run, in order
- 1Confirm every unit has Parallel Mode enabled
- 2Check that all battery cables are the same length, as the manual requires
- 3Inspect the parallel communication cables
- 4Confirm all units share the same battery bank
Fixes
- Equalise the battery cable lengths and reconnect
- Enable parallel mode on every unit
- Reseat the communication cables and restart the system
When to escalate
If reverse power persists with equal cabling and all units in parallel mode, the distributor should check the parallel control board.
Fix it with the right tools
Check the system around the fault before replacing parts: load, battery bank, PV string and commissioning settings. If you need a second opinion, send the code and your inverter model to our team.
Before you open the inverter
- Isolate both the AC and DC sides, then confirm the display is dead before touching terminals.
- Use insulated tools and one hand where possible. DC arcs do not self-extinguish like AC.
- If you see burnt terminals, swollen cells, leaking electrolyte or a burning smell, stop and escalate instead of resetting the fault.
Questions installers ask
What does Beve 60 mean?
Parallel failure: the code name refers to negative (reverse) power on a unit in the parallel system; the manual's description is simply 'Parallel failure'.
How do I fix Beve 60?
Equalise the battery cable lengths and reconnect Enable parallel mode on every unit Reseat the communication cables and restart the system
When should I escalate Beve 60?
If reverse power persists with equal cabling and all units in parallel mode, the distributor should check the parallel control board.
Can I reset Beve 60 myself?
Only after isolating the AC and DC sides and running the checks above. If Beve 60 returns immediately, stop resetting it and escalate; a repeating fault usually points to a real circuit, battery or hardware problem.
Which models show Beve 60?
Beve 60 is documented for MEGA 6/8/10/12 kW single-phase hybrid inverter — inverter fault. Confirm the code on your own unit's display or manual before ordering parts.
More Beve error codes
- Beve 01Cooling fan is locked and not turning while the inverter is switched on.
- Beve 02Inverter temperature has exceeded its protection point.
- Beve 03Battery voltage is above the inverter's high battery cut-off.
- Beve 05Output short circuit detected on the inverter AC output.
- Beve 06Inverter output voltage is above the acceptable window; the manual's troubleshooting table puts this above 260 Vac.
- Beve 07Overload: the inverter has been running above its rating (102% in the manual's note) until the overload time expired.
Guidance reviewed 17 October 2026 by the Mishka Energy installer team. Error codes vary by brand, model family and firmware; confirm against the manufacturer manual.
Back to troubleshooting