IPV Pro series (IPV-4K24U Pro, IPV-6K48U Pro, IPV-12K48U) — inverter warning code
Itel Energy 06 error code
Remote shutdown is enabled, typically from the monitoring app over Wi-Fi, so the inverter is being held off remotely.
Likely causes
- Remote shutdown enabled in the app or Wi-Fi monitoring stick
- A shutdown command that was not cleared after the last remote session
- Communication-stick glitch holding the shutdown state
Checks to run, in order
- 1Open the monitoring app and check the remote-shutdown state for this inverter
- 2Check the Wi-Fi stick indicator and its connection to the inverter
- 3Restart the inverter and see whether the warning clears
Fixes
- Disable remote shutdown in the app
- Restart the inverter after disabling the command
- Re-pair or replace the Wi-Fi communication stick if it does not respond
When to escalate
If remote shutdown cannot be disabled from the app, escalate to the distributor to clear the command or replace the communication stick.
Fix it with the right tools
Check the system around the fault before replacing parts: load, battery bank, PV string and commissioning settings. If you need a second opinion, send the code and your inverter model to our team.
Before you open the inverter
- Isolate both the AC and DC sides, then confirm the display is dead before touching terminals.
- Use insulated tools and one hand where possible. DC arcs do not self-extinguish like AC.
- If you see burnt terminals, swollen cells, leaking electrolyte or a burning smell, stop and escalate instead of resetting the fault.
Questions installers ask
What does Itel Energy 06 mean?
Remote shutdown is enabled, typically from the monitoring app over Wi-Fi, so the inverter is being held off remotely.
How do I fix Itel Energy 06?
Disable remote shutdown in the app Restart the inverter after disabling the command Re-pair or replace the Wi-Fi communication stick if it does not respond
When should I escalate Itel Energy 06?
If remote shutdown cannot be disabled from the app, escalate to the distributor to clear the command or replace the communication stick.
Can I reset Itel Energy 06 myself?
Only after isolating the AC and DC sides and running the checks above. If Itel Energy 06 returns immediately, stop resetting it and escalate; a repeating fault usually points to a real circuit, battery or hardware problem.
Which models show Itel Energy 06?
Itel Energy 06 is documented for IPV Pro series (IPV-4K24U Pro, IPV-6K48U Pro, IPV-12K48U) — inverter warning code. Confirm the code on your own unit's display or manual before ordering parts.
More Itel Energy error codes
- Itel Energy 01Display code 01 covers two events: as a warning it signals output overload (flashing fault LED, two beeps per second); as a fault it signals DC bus over-voltage (solid fault LED, output switched off).
- Itel Energy 02Display code 02 covers two events: as a warning it signals the upper cooling fan is locked (three beeps); as a fault it signals DC bus under-voltage (solid fault LED, output switched off).
- Itel Energy 03Display code 03 covers two events: as a warning it signals the lower cooling fan is locked (three beeps); as a fault it signals that the DC bus soft-start sequence failed (solid fault LED).
- Itel Energy 04Grid voltage is above the upper limit of the inverter's grid window; warning only, with no buzzer alarm.
- Itel Energy 05In a parallel system the AC outputs of the units are not connected together, or a unit is running on a different phase.
- Itel Energy 07The load on the inverter's second AC output exceeds that output's rating; warning only, with no buzzer alarm.
Guidance reviewed 17 October 2026 by the Mishka Energy installer team. Error codes vary by brand, model family and firmware; confirm against the manufacturer manual.
Back to troubleshooting