IVGM5-8K LP2G1 hybrid inverters (fault code list, solid fault LED)
Felicity 53 error code
AC current DC-component fault: a DC component was detected in the inverter's AC output current.
Likely causes
- Output-stage fault producing an asymmetric current
- DC or half-wave load on the backup output
- Current-sensor or measurement fault
- Damage after a surge
Checks to run, in order
- 1Clamp the AC output and look for a DC component
- 2Disconnect DC or half-wave loads and retest
- 3Restart 2-3 times
- 4Inspect the output wiring for a partial short
Fixes
- Remove the DC or half-wave load
- Restart and re-measure
- If the DC component remains with no load, book service
When to escalate
A persistent DC current component with a clean load is an internal inverter fault - escalate to the distributor.
Fix it with the right tools
Check the system around the fault before replacing parts: load, battery bank, PV string and commissioning settings. If you need a second opinion, send the code and your inverter model to our team.
Before you open the inverter
- Isolate both the AC and DC sides, then confirm the display is dead before touching terminals.
- Use insulated tools and one hand where possible. DC arcs do not self-extinguish like AC.
- If you see burnt terminals, swollen cells, leaking electrolyte or a burning smell, stop and escalate instead of resetting the fault.
Questions installers ask
What does Felicity 53 mean?
AC current DC-component fault: a DC component was detected in the inverter's AC output current.
How do I fix Felicity 53?
Remove the DC or half-wave load Restart and re-measure If the DC component remains with no load, book service
When should I escalate Felicity 53?
A persistent DC current component with a clean load is an internal inverter fault - escalate to the distributor.
Can I reset Felicity 53 myself?
Only after isolating the AC and DC sides and running the checks above. If Felicity 53 returns immediately, stop resetting it and escalate; a repeating fault usually points to a real circuit, battery or hardware problem.
Which models show Felicity 53?
Felicity 53 is documented for IVGM5-8K LP2G1 hybrid inverters (fault code list, solid fault LED). Confirm the code on your own unit's display or manual before ordering parts.
More Felicity error codes
- Felicity 04Low cell voltage / over-discharge protection.
- Felicity 05PV over-current fault: the PV input current exceeded the inverter's PV input limit.
- Felicity 18PV short-circuit fault on the PV input; in the warning list the same number means battery under-voltage alarm.
- Felicity 19Battery open-circuit alarm: the inverter no longer detects a battery on its terminals.
- Felicity 20Battery SOC low alarm: the battery's state of charge has fallen to the low-SOC warning threshold.
- Felicity 21BMS communication alarm: abnormal communication between battery and inverter in non-SOC mode.
Guidance reviewed 17 October 2026 by the Mishka Energy installer team. Error codes vary by brand, model family and firmware; confirm against the manufacturer manual.
Back to troubleshooting