HESP three-phase hybrid (HESP H3/SH3 8-12 kW); code not listed in the single-phase HESP table
SRNE 25 error code
Bus short circuit (BusShort): a short was detected on the internal DC bus.
Likely causes
- Internal power-stage failure
- Failed bus capacitor
- Damage after a surge or lightning event
Checks to run, in order
- 1Do not repeatedly restart the unit
- 2Check for a burnt smell or discoloration at the vents
- 3Confirm battery and PV voltages are normal
- 4Check whether a surge event preceded the fault
Fixes
- Take the unit out of service
- Have the distributor replace the power stage
When to escalate
A bus short is a serious internal failure; isolate the inverter and send it to SRNE service without further restart attempts.
Fix it with the right tools
Check the system around the fault before replacing parts: load, battery bank, PV string and commissioning settings. If you need a second opinion, send the code and your inverter model to our team.
Before you open the inverter
- Isolate both the AC and DC sides, then confirm the display is dead before touching terminals.
- Use insulated tools and one hand where possible. DC arcs do not self-extinguish like AC.
- If you see burnt terminals, swollen cells, leaking electrolyte or a burning smell, stop and escalate instead of resetting the fault.
Questions installers ask
What does SRNE 25 mean?
Bus short circuit (BusShort): a short was detected on the internal DC bus.
How do I fix SRNE 25?
Take the unit out of service Have the distributor replace the power stage
When should I escalate SRNE 25?
A bus short is a serious internal failure; isolate the inverter and send it to SRNE service without further restart attempts.
Can I reset SRNE 25 myself?
Only after isolating the AC and DC sides and running the checks above. If SRNE 25 returns immediately, stop resetting it and escalate; a repeating fault usually points to a real circuit, battery or hardware problem.
Which models show SRNE 25?
SRNE 25 is documented for HESP three-phase hybrid (HESP H3/SH3 8-12 kW); code not listed in the single-phase HESP table. Confirm the code on your own unit's display or manual before ordering parts.
More SRNE error codes
- SRNE 01Battery undervoltage alarm: the battery voltage has fallen below the [Batt. Under volt. alarm] value under Battery Setup, and the alarm does not by itself stop the output.
- SRNE 02Battery discharge average current overcurrent, detected by software (BatOverCurrSw); the inverter limits or stops discharge.
- SRNE 03Battery not connected (BatOpen): the inverter cannot see a battery on the DC side and stops the output.
- SRNE 04Battery undervoltage stop-discharge (BatLowEod): the battery has reached the low-voltage cut-off and the inverter has stopped discharging.
- SRNE 05Battery overcurrent detected by hardware protection (BatOverCurrHw); the inverter shuts the output down.
- SRNE 06Charging overvoltage protection (BatOverVolt): battery voltage rose above the over-voltage cut-off and charging was stopped.
Guidance reviewed 17 October 2026 by the Mishka Energy installer team. Error codes vary by brand, model family and firmware; confirm against the manufacturer manual.
Back to troubleshooting