SUN-5-12K-SG01HP3-EU-DM2 three-phase hybrid (F-series table)
Deye F05 error code
Control-board EEPROM read failure.
Likely causes
- Interrupted firmware update
- EEPROM memory corruption
- Control-board supply glitch or EMI
- Failed control board
Checks to run, in order
- 1Record the current settings and firmware version
- 2Power-cycle the inverter from DC and AC
- 3Read the fault history
Fixes
- Restart the inverter three times
- Restore factory settings and re-enter the site configuration
- Re-apply the correct firmware if an update was interrupted
When to escalate
If F05 returns after a clean restart and firmware reflash, the control board must be replaced by the distributor.
Fix it with the right tools
Check the system around the fault before replacing parts: load, battery bank, PV string and commissioning settings. If you need a second opinion, send the code and your inverter model to our team.
Before you open the inverter
- Isolate both the AC and DC sides, then confirm the display is dead before touching terminals.
- Use insulated tools and one hand where possible. DC arcs do not self-extinguish like AC.
- If you see burnt terminals, swollen cells, leaking electrolyte or a burning smell, stop and escalate instead of resetting the fault.
Questions installers ask
What does Deye F05 mean?
Control-board EEPROM read failure.
How do I fix Deye F05?
Restart the inverter three times Restore factory settings and re-enter the site configuration Re-apply the correct firmware if an update was interrupted
When should I escalate Deye F05?
If F05 returns after a clean restart and firmware reflash, the control board must be replaced by the distributor.
Can I reset Deye F05 myself?
Only after isolating the AC and DC sides and running the checks above. If Deye F05 returns immediately, stop resetting it and escalate; a repeating fault usually points to a real circuit, battery or hardware problem.
Which models show Deye F05?
Deye F05 is documented for SUN-5-12K-SG01HP3-EU-DM2 three-phase hybrid (F-series table). Confirm the code on your own unit's display or manual before ordering parts.
More Deye error codes
- Deye F01PV input polarity is reversed at one or both DC inputs.
- Deye F02PV insulation resistance to earth is below the safety limit.
- Deye F03Ground fault detected on the PV array (GFDI).
- Deye F04GFDI ground-failure alarm: the PV array or inverter is not properly earthed.
- Deye F06Control-board EEPROM write failure.
- Deye F07DC-DC stage 1 could not raise the bus voltage from PV or battery.
Guidance reviewed 17 October 2026 by the Mishka Energy installer team. Error codes vary by brand, model family and firmware; confirm against the manufacturer manual.
Back to troubleshooting